Wicked lasers S3 Arctic Series Uživatelský manuál stáhnout pdf (Strana 16)

WICKED LASERS Master Guide | 25WICKED LASERS Master Guide | 24

WWW.WICKEDLASERS.COM

SmartSwitch™ 2.0 Codes:

After unlocking your laser, you can select among the active modes

by using one of these following codes when pressing the button:

▪ A long hold (holding down briey for less than a second)

cycles between high power and low power.

▪ A short hold cycles Strobe mode to Continuous Wave mode.

▪ Clicking 3 times within 2 seconds goes into SOS mode.

▪ From SOS mode, one quick press will change it into

Beacon mode.

▪ From Beacon mode, one quick press will change it to low

power Strobe mode.

▪ Holding the switch for 3 seconds will go to Tactical

Hibernation mode. The middle LED will be ashing to

indicate this.

How To Use The SmartSwitch™ 2.0 How To Use The SmartSwitch™ 2.0

Push the Power Button on the

Tailcap to turn on your laser.

The rst LED will start ashing

indicating the laser is ready to

be unlocked.

Click on the SmartSwitch™

button. After the rst click the

rst LED will be ON and the

second LED will start ashing.

➡

FLASHING

➡

FLASHING

Click the button again. The

rst and second LEDs will be

steady and the third LED will

start ashing.

Click the button a third time.

Both rst and second LEDs

will start ashing.

➡

FLASHING

➡

FLASHING

➡

FLASHING

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 26 27

Komentáře k této Příručce

Žádné komentáře

Wicked lasers S3 Arctic Series Uživatelský manuál Strana 16

Komentáře k této Příručce

Související produkty a manuály pro Měření, testování a kontrola Wicked lasers S3 Arctic Series